Feel free to refine and fill in the details as you see fit. Then, do a second pass on your glass prints with a metallic sharpie marker. First, sketch out your calligraphy by hand. Use glass prints for wedding decor Table Numbersįirst up on our list of unique ways to use glass prints-a clever wedding hack for you: Go zero-waste and DIY your table numbers. But did you know that Fracture glass prints can be used for so much more? Here’s our roundup of 3 unique ways to use glass prints you may not have thought of! 1. If you’re planning to put up glass prints on a shelf or very narrow table, make sure you have enough space-the Small Stand is 3.3” deep and the Medium Stand is 4.1″ deep.We talk a lot about glass prints being stunning home decor pieces-whether you print family photos or your favorite art.Simply set it in and let the stand support its weight. The glass edge and backing fit perfectly within the front ridge of the stand.Our black, powder-coated steel Print Stands are a low-profile way to display our smaller prints without wall mounting.Our stands are perfect for tabletop or desk display Follow the Command Strip instructions to make sure they’re perfectly adhered.ģ. Press the strips onto the print, and then the print onto your wall.For optimal placement, each strip should be half an inch from the edge of the backing. Use the Medium strips for our smaller print sizes and the Large strips for the largest sizes, following the guide below.This is important for keeping your print backing intact and damage-free if you ever move it. Use the 3M “ Picture Hanging Strips”- these have two sides that click together like Velcro.Did you know you can use Command Strips to put up glass prints? Perhaps you’re renting your home or simply want to avoid getting out the spackle, if you decide to do some rearranging.Use Command Strips for screw-free hanging Insert your screw right below the mark, and set your print on the screw as usual.Ģ.You’ll see a perfectly marked spot with the toothpaste. Once you’ve flattened it against the wall, pull the print away from it. Lift your print up and press it flat against the wall’s surface where you want to hang it.To avoid a giant glob of toothpaste, use another tool first so that you can apply it with more precision.For our prints, a good spot is right at the top curve of the keyhole cutout. Dab a little spot of toothpaste right on the keyhole where the screw will be placed.Try the toothpaste method for screw alignment when you put up glass prints If you need to make sure your print is precisely lined up with another print or something else on your wall, don’t skip the measuring!.Then, you can put your screw in the wall based on where you want the top of the print to end up. TIP: Measure from the top glass edge of your print to the top of the keyhole cutout on the backing to get an exact distance.The keyhole cutout in the backing will fit right over the top of the screw. To put up glass prints, insert the screw into the wall using a drill or screwdriver until it’s close to flush with the wall.Yep, just the one screw is enough to support the weight of all of our print sizes.Use the included screw and a ruler to measure
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |